Shenzhen heat shrink packaging machine is a kind of packaging equipment that has been favored in recent years. Customers have handled many subsequent packaging processes. Many customers did not know what kind of packaging method should be selected to meet the packaging needs when they needed the heat shrinkable machine. In the past, Xiaobian once again shared the packaging method of the heat shrinkable packaging machine with us.
1. The packaging method of Shenzhen heat shrink packaging machine is to stop sealing in four directions. Select packaging film to stop wrapping and sealing around the goods in four directions. Use heat sealing to stop the joints at the joints. This packaging method is classified as fully enclosed packaging, which is suitable for packaging of goods that require sealing.
2. The second packaging method of the heat shrinkable machine bag is to close only one end of the product and stop sealing in other directions. This method first cuts the packaging film into a square bottom bag, and then the square bottom bag wraps the product. Get up, and then use the heat shrink method to stop packaging. This method is suitable for packaging a certain number of goods together without singling, in order to facilitate transportation and bulk sales.
3. The third packaging method of the heat shrinkable machine package is to close the product in the middle and stop sealing in other directions. Select a packaging film to wrap the product in the sleeve, and then use heat shrinkage to stop the packaging. The packaging is finished Later, there is an open tooth in the middle of the packaged goods.
Shenzhen heat shrink packaging machine daily maintenance and troubleshooting
1. In order to avoid overheating and burning of the thermal cycle fan (motor) under frequent starting conditions, pay attention to the continuous working time limit of the heat shrinking machine when using: when the packaging speed is 12 seconds / piece, it can work continuously for about 6 hours When the packing speed is 6 seconds / piece, it can work continuously for about 3 hours, and so on. Of course, the above time is also related to factors such as ambient temperature, which can be handled as appropriate according to the actual heating of the motor.
2. When the machine is working, due to the extremely high surface temperature of the sealing and cutting blades and other heating components, the Shenzhen heat shrink packaging machine must not be touched by hand or other items, otherwise there is a danger of burns or damage.
3. In order to extend the service life of the sealing and cutting blades, the following principles must be followed when adjusting the sealing and cutting time: that is, from low to high, proceed slowly. As long as the requirements for sealing and cutting are met, the time is as short as possible. It must be too long or adjusted to the position, otherwise the sealing and cutting blades and accessories will burn.
4. The machine must be reliably grounded to protect the personal safety of the operator.